In late August 2026, Crafted Exterior Services put new 26-gauge standing seam metal roofs on a house, a garage and a shed in Middleway, WV, in Jefferson County. Every old roof came off down to the decking first, so the crew could check the wood before the metal went on.
Project at a glance
- Location: Middleway, Jefferson County, WV
- Completed: August 2026
- Buildings: House, garage and shed
- Service: standing seam metal roofing
- Roof: 26-gauge standing seam metal panels with matching drip edge and metal ridge cap
- Underlayment: Synthetic underlayment with high-heat ice and water shield along the eaves and valleys
- Pipe flashing: Lifetime Ultimate pipe flashing boots
About the area
Middleway is a small village in Jefferson County, West Virginia, in the lower Shenandoah Valley (Middleway on Wikipedia).
Before

Tear-off and installation


The challenge and how we solved it
The challenge: three separate roofs on one property (the house, a detached garage and a shed) all needed replacing, and the homeowner wanted a long-lasting metal roof on every building.
The solution: the crew stripped each building down to the decking, dealt with a damaged spot found in the old wood, and installed the same 26-gauge standing seam system on all three so the property has one matching look.
What we did
- Removed the existing roofing on the house, garage and shed down to the decking so every sheet could be inspected.
- Installed high-heat ice and water shield along all eaves and valleys.
- Installed synthetic underlayment across each roof.
- Installed 26-gauge standing seam metal panels across the entire roof of each building.
- Installed matching metal drip edge around the perimeter and metal ridge cap along the peaks.
- Inspected all flashing and replaced it as needed, including around the chimney.
- Installed Lifetime Ultimate pipe flashing boots, which are guaranteed for the life of the roof.
- Cleaned up the work area and hauled away all debris.
The finished project





Why these materials
26-gauge standing seam metal. Standing seam panels lock together at raised seams, so the fasteners are hidden from the weather instead of exposed through the face of the panel. 26-gauge steel is a common residential thickness for this style of roof.
High-heat ice and water shield. Metal roofs get hot in the summer sun, so a high-temperature membrane is used along the eaves and valleys where ice dams and wind-driven rain push water.
Matching trim. Drip edge and ridge cap in the same metal give the edges and peaks a finished look and keep water out of the seams.
Keeping a metal roof in good shape
- Clear leaves and branches from the panels and gutters in the fall so water runs freely off the roof.
- Check the roof from the ground after major wind storms. The National Weather Service Baltimore/Washington office posts storm warnings for this area.
- Snow slides off a metal roof in sheets. Keep walkways and parked cars clear of the eaves after a snowfall, or ask about adding snow guards.
- Have the pipe boots, chimney flashing and fasteners looked at every few years. Those spots are where small leaks start.
- Use a soft brush and garden hose for cleaning. Avoid pressure washers and abrasive pads that can scratch the painted finish.
Frequently asked questions
26-gauge standing seam metal panels, with matching metal drip edge and metal ridge cap, over synthetic underlayment and high-heat ice and water shield.
The house, the detached garage and a shed, all in the same standing seam metal.
Snow guards were not part of this job. Crafted can add them to a standing seam roof if a homeowner wants them.
Yes. Crafted serves Middleway, Charles Town, Kearneysville and the rest of Jefferson County, West Virginia, along with Berkeley County.
Planning a metal roof in Jefferson County, WV?
Crafted Exterior Services serves Middleway, Charles Town and the rest of Jefferson County. See our Charles Town, WV roofing services, learn about standing seam metal roofing, or request a free estimate.
